Wiki guide · Community guide
How to Build a Dirt Dam
Build a bank from deposited dirt, test whether it holds water, and repair the spots where water gets through or goes around it.
Place a continuous bank across the water route
Deposited dirt can hold back water in Groundwork Simulator. Start with a short test bank in a place where you can see the water on both sides. Place excavated dirt across the route in a continuous line, and close the gaps and low spots before testing.
Check the ends where your dirt meets the existing ground. Walk the bank and look for a way around either end. The loader’s pile-only mode is useful if you need to collect deposited dirt without cutting into the original ground.
Watch where the water passes the bank
Watch where the water collects after building the bank. If you use a pump to fill the area, stay nearby and monitor the rising water.
- Water passes through a gap
- Add dirt to close the opening and watch the same spot again.
- Water goes around the bank
- Extend the end where it gets through, then check the new join with the existing ground.
- Water crosses a low part of the top
- Pause the supply pump if you are using one. Build up the low section and recheck it as the level rises.
Recheck the bank after reshaping it or raising the water level. See the player-confirmed dirt dam notes and pump and hose setup.