Wiki guide · Community guide

How to Set Up the Water Pump Pro

Tow and place the Water Pump Pro, connect its intake and discharge hoses, and check that water reaches your washplant.

Tow and place the Water Pump Pro

The Water Pump Pro is a towable diesel pump. XYZ Studio lists its maximum flow at five times the portable pump’s maximum. Update 0.1.3.3 gives it a folding towing stand and improves placement on slopes.

Choose a spot where the intake hose can reach the water source and the discharge can reach the receiving pond or equipment. Use the stand and hitch actions, then check that the pump sits where you want it after unhitching.

Flow rating from XYZ Studio’s 0.1.3.3 release notes.

Connect the intake and discharge

  1. Identify the fittings. Check the fitting labels in the interaction prompts to identify the pump’s input and output.
  2. Submerge the intake. Attach a hose to the input fitting and place the loose end below the water surface.
  3. Route the discharge. Attach the second hose to the output fitting. Connect its loose end to the receiving equipment’s inlet, or place it where you want water delivered.

See the pump hose guide for help routing and connecting hoses.

Start the pump and check flow

Start the pump and check the delivery point. If you are filling a pond, watch its water level. If you are supplying a washplant, verify water reaches the equipment before feeding paydirt. Follow the wash-line startup sequence for the rest of the setup.

Troubleshoot a Water Pump Pro with no flow

  • Check the current water level. The intake end needs to stay submerged while the pump runs.
  • Trace both hoses. Follow the source hose to the pump input, then trace the pump output to the receiving inlet or delivery point.
  • Check the pump. Confirm it is running and check again at the delivery point.

For a washplant with several pumps, see the water supply checklist. Compare equipment in the Water Pump Pro catalog entry.

Next guideCheck a washplant with no water